CBSE Class 10 · Boards 2027 · NCERT 2026-27 syllabus
NCERT Solutions Class 10 Science Chapter 11 Electricity
Try each question first: pick an option or type your final answer, then see the full step-by-step solution. Stuck? Open the first step as a hint. Free, no account needed.
Boards begin February 2027
Pre-boards are in December
Electricity is in Effects of Current, which carries 13 of the 80 marks in the 2026-27 CBSE Science paper
38 NCERT textbook questions from Chapter 11
In-text questions
In-text Q1 · Section 11.12 marks
What does an electric circuit mean?
Step-by-step solution
[1 mark] An electric circuit is a continuous and closed conducting path of an electric current.
[0.5 mark] It comprises a source of potential difference (cell/battery), connecting wires, a switch (plug key) and electrical components.
[0.5 mark] Current flows only when the path is closed; opening the switch breaks the circuit and stops the current.
Answer:A continuous and closed conducting path along which an electric current flows.
Let the resistance of an electrical component remains constant while the potential difference across the two ends of the component decreases to half of its former value. What change will occur in the current through it?
Step-by-step solution
[0.5 mark] Ohm's law: I = V/R. Here R remains constant.
[0.5 mark] New potential difference V' = V/2.
[0.5 mark] New current I' = V'/R = (V/2)/R = (1/2)(V/R) = I/2.
[0.5 mark] Hence the current through the component reduces to half of its initial value.
[0.5 mark] Conclusion: when a small resistor is in parallel with much larger resistors, the equivalent resistance is essentially equal to the smallest resistance.
Answer:Both cases give an equivalent resistance ≈ 1 Ω (slightly less than 1 Ω).
An electric lamp of 100 Ω, a toaster of resistance 50 Ω, and a water filter of resistance 500 Ω are connected in parallel to a 220 V source. What is the resistance of an electric iron connected to the same source that takes as much current as all three appliances, and what is the current through it?
(a) How much current will an electric bulb draw from a 220 V source, if the resistance of the bulb filament is 1200 Ω? (b) How much current will an electric heater coil draw from a 220 V source, if the resistance of the heater coil is 100 Ω?
Step 1[0.5 mark] Using Ohm's law: I = V/R.
Step-by-step solution
[0.5 mark] Using Ohm's law: I = V/R.
[1 mark] (a) V = 220 V, R = 1200 Ω ⇒ I = 220/1200 = 0.183 A ≈ 0.18 A.
[1 mark] (b) V = 220 V, R = 100 Ω ⇒ I = 220/100 = 2.2 A.
[0.5 mark] Note: at the same voltage, a lower-resistance device (heater) draws more current than a higher-resistance device (bulb).
The potential difference between the terminals of an electric heater is 60 V when it draws a current of 4 A from the source. What current will the heater draw if the potential difference is increased to 120 V?
A wire of given material having length l and area of cross-section A has a resistance of 4 Ω. What would be the resistance of another wire of the same material having length l/2 and area of cross-section 2A?
Step 1[0.5 mark] For a wire of the same material, R = ρl/A.
Step-by-step solution
[0.5 mark] For a wire of the same material, R = ρl/A.
An electric lamp, whose resistance is 20 Ω, and a conductor of 4 Ω resistance are connected to a 6 V battery. Calculate (a) the total resistance of the circuit, (b) the current through the circuit, and (c) the potential difference across the electric lamp and conductor.
Step-by-step solution
[0.5 mark] The lamp (20 Ω) and the conductor (4 Ω) are in series with a 6 V battery.
A piece of wire of resistance R is cut into five equal parts. These parts are then connected in parallel. If the equivalent resistance of this combination is R', then the ratio R/R' is –
Step-by-step solution
Each of the 5 equal parts has resistance R/5.
Connecting five resistors of (R/5) in parallel: 1/R' = 5 × (1/(R/5)) = 5 × (5/R) = 25/R.
Two conducting wires of the same material and of equal lengths and equal diameters are first connected in series and then parallel in a circuit across the same potential difference. The ratio of heat produced in series and parallel combinations would be –
Step-by-step solution
Let each wire have resistance R. Series: Rs = 2R. Parallel: Rp = R/2.
A copper wire has diameter 0.5 mm and resistivity of 1.6 × 10⁻⁸ Ω m. What will be the length of this wire to make its resistance 10 Ω? How much does the resistance change if the diameter is doubled?
Step 1[0.5 mark] Given d = 0.5 mm = 5 × 10⁻⁴ m, ρ = 1.6 × 10⁻⁸ Ω m, R = 10 Ω.
Step-by-step solution
[0.5 mark] Given d = 0.5 mm = 5 × 10⁻⁴ m, ρ = 1.6 × 10⁻⁸ Ω m, R = 10 Ω.
[1 mark] Area A = πd²/4 = π × (5 × 10⁻⁴)² / 4 = π × 25 × 10⁻⁸ / 4 ≈ 1.963 × 10⁻⁷ m².
[1.5 marks] From R = ρl/A: l = RA/ρ = (10 × 1.963 × 10⁻⁷) / (1.6 × 10⁻⁸) = (1.963 × 10⁻⁶) / (1.6 × 10⁻⁸) ≈ 122.7 m.
[1 mark] If diameter is doubled, new area = π(2d)²/4 = 4A. So new resistance R' = ρl/(4A) = R/4.
[1 mark] Hence the resistance becomes 10/4 = 2.5 Ω (reduces to one-fourth).
Answer:l ≈ 122.7 m. With doubled diameter, R becomes one-fourth (= 2.5 Ω).
When a 12 V battery is connected across an unknown resistor, there is a current of 2.5 mA in the circuit. Find the value of the resistance of the resistor.
Step-by-step solution
[0.5 mark] Given V = 12 V and I = 2.5 mA = 2.5 × 10⁻³ A.
A battery of 9 V is connected in series with resistors of 0.2 Ω, 0.3 Ω, 0.4 Ω, 0.5 Ω and 12 Ω, respectively. How much current would flow through the 12 Ω resistor?
Step-by-step solution
[0.5 mark] For series resistors, Rtotal = sum of resistances.
Several electric bulbs designed to be used on a 220 V electric supply line, are rated 10 W. How many lamps can be connected in parallel with each other across the two wires of 220 V line if the maximum allowable current is 5 A?
Step 1[1 mark] Current drawn by one bulb: I₀ = P/V = 10 W / 220 V = 1/22 A ≈ 0.0455 A.
Step-by-step solution
[1 mark] Current drawn by one bulb: I₀ = P/V = 10 W / 220 V = 1/22 A ≈ 0.0455 A.
[0.5 mark] All bulbs are in parallel, so total current = n × I₀.
[1 mark] Set n × (1/22) ≤ 5 ⇒ n ≤ 110.
[0.5 mark] Therefore at most 110 bulbs of 10 W can be connected in parallel without exceeding 5 A.
A hot plate of an electric oven connected to a 220 V line has two resistance coils A and B, each of 24 Ω resistance, which may be used separately, in series, or in parallel. What are the currents in the three cases?
Step-by-step solution
[1.5 marks] Case (a) — one coil only: R = 24 Ω. I = V/R = 220 / 24 = 9.17 A.
[1.5 marks] Case (b) — series combination: Rs = 24 + 24 = 48 Ω. I = 220 / 48 ≈ 4.58 A.
Compare the power used in the 2 Ω resistor in each of the following circuits: (i) a 6 V battery in series with 1 Ω and 2 Ω resistors, and (ii) a 4 V battery in parallel with 12 Ω and 2 Ω resistors.
Step-by-step solution
[1 mark] Case (i): 1 Ω and 2 Ω in series with 6 V battery. Rtotal = 1 + 2 = 3 Ω.
[1.5 marks] Current I = V/R = 6 / 3 = 2 A. Power dissipated in 2 Ω: P₁ = I²R = (2)² × 2 = 8 W.
[0.5 mark] Case (ii): 12 Ω and 2 Ω each connected directly to the 4 V battery (parallel).
[1.5 marks] Voltage across the 2 Ω resistor = 4 V. Power in 2 Ω: P₂ = V²/R = (4)² / 2 = 16/2 = 8 W.
[0.5 mark] Therefore P₁ = P₂ = 8 W; the ratio is 1 : 1.
Two lamps, one rated 100 W at 220 V, and the other 60 W at 220 V, are connected in parallel to electric mains supply. What current is drawn from the line if the supply voltage is 220 V?
Step-by-step solution
[0.5 mark] Each lamp gets the full supply voltage of 220 V (parallel connection).
[1 mark] Current in 100 W lamp: I₁ = P₁/V = 100 / 220 = 5/11 A ≈ 0.455 A.
[1 mark] Current in 60 W lamp: I₂ = P₂/V = 60 / 220 = 3/11 A ≈ 0.273 A.
[0.5 mark] Total line current I = I₁ + I₂ = (100 + 60)/220 = 160/220 = 8/11 A ≈ 0.73 A.
Board examiners mark every step. Photograph your written answer and see the marks for each step, and exactly where they were lost. Your first answer check is free.
Questions from the NCERT Class 10 Science textbook; the solutions are written by LazyTopper. LazyTopper is an independent platform and is not affiliated with CBSE or NCERT.