CBSE Class 10 · Boards 2027 · NCERT 2026-27 syllabus
NCERT Exemplar Solutions Class 10 Science Chapter 3 Metals and Non-metals
Try each question first: pick an option or type your final answer, then see the full step-by-step solution. Stuck? Open the first step as a hint. Free, no account needed.
Boards begin February 2027
Pre-boards are in December
Metals and Non-metals is in Chemical Substances – Nature and Behaviour, which carries 25 of the 80 marks in the 2026-27 CBSE Science paper
30 NCERT Exemplar questions from Chapter 3
Multiple choice questions
Exemplar Q21 mark
The ability of metals to be drawn into thin wire is known as
Step-by-step solution
Ductility = drawn into thin wires.
Malleability = beaten into sheets. So drawn into wire = ductility. Answer: (A)
Aluminium is used for making cooking utensils. Which of the following properties of aluminium are responsible for the same?
(i) Good thermal conductivity
(ii) Good electrical conductivity
(iii) Ductility
(iv) High melting point
Step-by-step solution
Cooking utensils need to conduct heat to the food: (i) thermal conductivity ✓.
Cooking utensils heated on fire must not melt: (iv) high m.p. ✓.
Electrical conductivity (ii) and ductility (iii) are not relevant for cooking. Answer (d). Answer: (D)
What happens when calcium is treated with water?
(i) It does not react with water
(ii) It reacts violently with water
(iii) It reacts less violently with water
(iv) Bubbles of hydrogen gas formed stick to the surface of calcium
Step-by-step solution
Ca + 2H₂O → Ca(OH)₂ + H₂. Ca is less reactive than Na/K → less violent reaction (iii) ✓.
H₂ bubbles stick to Ca surface (Ca floats) — characteristic observation (iv) ✓. Answer (d). Answer: (D)
Generally metals react with acids to give salt and hydrogen gas. Which of the following acids does not give hydrogen gas on reacting with metals (except Mn and Mg)?
Step-by-step solution
HNO₃ is an oxidising acid. The H released gets oxidised back to water by HNO₃ — so H₂ is not collected.
Instead products are NO, NO₂ etc. (Mn and Mg are exceptions — they give H₂ with dilute HNO₃.) Answer: (C)
Metals are refined by using different methods. Which of the following metals are refined by electrolytic refining?
(i) Au
(ii) Cu
(iii) Na
(iv) K
Step-by-step solution
Electrolytic refining is used for less reactive metals like Cu, Au, Ag, Zn.
Na and K are very reactive — they cannot be refined by electrolysis of aqueous solutions (would react with water). They are obtained by electrolysis of molten chlorides directly. So (i) Au and (ii) Cu are refined electrolytically. Answer: (A)
An element A is soft and can be cut with a knife. This is very reactive to air and cannot be kept open in air. It reacts vigorously with water. Identify the element from the following
Step-by-step solution
Soft (cuts with knife) + very reactive with air/water → alkali metal.
Sodium (Na) fits: soft enough to cut, reacts vigorously with water (2Na + 2H₂O → 2NaOH + H₂), stored under kerosene. Answer: (B)
During extraction of metals, electrolytic refining is used to obtain pure metals. (a) Which material will be used as anode and cathode for refining of silver metal by this process? (b) Suggest a suitable electrolyte also. (c) In this electrolytic cell, where do we get pure silver after passing electric current?
Step-by-step solution
[1 mark] (a) Anode = impure Ag (to be refined); Cathode = pure Ag strip.
[1 mark] (b) Electrolyte must be a soluble Ag salt → AgNO₃ solution (with a little HNO₃).
[1 mark] (c) During electrolysis, Ag dissolves from anode → Ag⁺ moves through electrolyte → deposits as pure Ag on cathode. Impurities settle as anode mud.
Answer:Anode: impure Ag; Cathode: pure Ag; Electrolyte: AgNO₃ solution; Pure Ag deposits on cathode.
Generally, when metals are treated with mineral acids, hydrogen gas is liberated but when metals (except Mn and Mg), treated with HNO₃, hydrogen is not liberated, why?
Step-by-step solution
[1 mark] Most acids (HCl, H₂SO₄ dil): metal + acid → salt + H₂↑.
[0.5 mark] HNO₃ acts as an oxidising agent: H₂ is oxidised back to H₂O.
[0.5 mark] Instead of H₂, products like NO (with dilute HNO₃) or NO₂ (with conc HNO₃) are formed.
[1 mark] Mn and Mg are exceptions: with very dilute HNO₃, they release H₂ because the acid is too dilute to oxidise it fully.
Answer:HNO₃ is oxidising — re-oxidises H₂ to H₂O. Only very reactive Mn and Mg can give H₂ with very dilute HNO₃.
When a metal X is treated with cold water, it gives a basic salt Y with molecular formula XOH (Molecular mass = 40) and liberates a gas Z which easily catches fire. Identify X, Y and Z and also write the reaction involved.
Step-by-step solution
[1 mark] XOH = X + 17 (OH). Given mass = 40, so X = 40 − 17 = 23. X is Na (atomic mass 23).
[1 mark] Y = NaOH. Z = H₂ gas (catches fire — H₂ burns explosively).
[1 mark] Reaction: 2Na + 2H₂O → 2NaOH + H₂↑. So much heat is released that H₂ catches fire.
Answer:X = Na, Y = NaOH, Z = H₂. 2Na + 2H₂O → 2NaOH + H₂.
The following reaction takes place when aluminium powder is heated with MnO₂:
3MnO₂(s) + 4Al(s) → 3Mn(l) + 2Al₂O₃(l) + Heat
(a) Is aluminium getting reduced?
(b) Is MnO₂ getting oxidised?
A metal that exists as a liquid at room temperature is obtained by heating its sulphide in the presence of air. Identify the metal and its ore and give the reaction involved.
Step-by-step solution
[1 mark] Mercury is the only liquid metal at room temperature.
[0.5 mark] Mercury's main ore is cinnabar (HgS).
[0.5 mark] Roasting: 2HgS + 3O₂ → 2HgO + 2SO₂.
[1 mark] Further heating: 2HgO → 2Hg + O₂ (Hg has low thermal stability of oxide). So Hg is obtained simply by heating its sulphide in air.
An alkali metal A gives a compound B (molecular mass = 40) on reacting with water. The compound B gives a soluble compound C on treatment with aluminium oxide. Identify A, B and C and give the reaction involved.
Step-by-step solution
[1 mark] B has mol mass 40, formed by reaction of alkali metal with water → MOH. M = 40 − 17 = 23 → Na.
[1 mark] A = Na; B = NaOH (mol mass 40 = 23+16+1 ✓).
[1 mark] NaOH + Al₂O₃ (amphoteric) → sodium aluminate: Al₂O₃ + 2NaOH → 2NaAlO₂ + H₂O. So C = NaAlO₂.
Answer:A = Na; B = NaOH; C = NaAlO₂. 2Na+2H₂O→2NaOH+H₂; Al₂O₃+2NaOH→2NaAlO₂+H₂O.
A metal M does not liberate hydrogen from acids but reacts with oxygen to give a black colour product. Identify M and black coloured product and also explain the reaction of M with oxygen.
Step-by-step solution
[1 mark] Metal that doesn't react with dilute acids (no H₂) → below H in reactivity series. Candidates: Cu, Hg, Ag, Au.
[1 mark] Heated in air gives BLACK product → CuO is black. So M = Cu.
[1 mark] 2Cu(s) + O₂(g) → 2CuO(s). Combination reaction; Cu is oxidised (gains O).
A solution of CuSO₄ was kept in an iron pot. After few days the iron pot was found to have a number of holes in it. Explain the reason in terms of reactivity. Write the equation of the reaction involved.
Of the three metals X, Y and Z. X reacts with cold water, Y with hot water and Z with steam only. Identify X, Y and Z and also arrange them in order of increasing reactivity.
Step-by-step solution
[1 mark] More reactive metals react with cold water; less reactive ones need hot water; even less reactive need steam.
[1 mark] X reacts with cold water — most reactive of the three. E.g., Na or Ca.
[0.5 mark] Y reacts with hot water — moderate reactivity. E.g., Mg.
[0.5 mark] Z reacts with steam only — least reactive of the three. E.g., Fe or Al.
[1 mark] Reactivity order (increasing): Z < Y < X. So Fe < Mg < Na.
[1 mark] (General reactivity series: K > Na > Ca > Mg > Al > Zn > Fe > Pb > H > Cu > Hg > Ag > Au.)
Answer:X = Na (or Ca); Y = Mg; Z = Fe (or Al). Increasing reactivity: Z < Y < X.
Board examiners mark every step. Photograph your written answer and see the marks for each step, and exactly where they were lost. Your first answer check is free.
Questions from the NCERT Class 10 Science Exemplar Problems; the solutions are written by LazyTopper. LazyTopper is an independent platform and is not affiliated with CBSE or NCERT.